Proficio PCB version 5.x and the Proficio Enclosure

Ron / W4MMP

Hi Folks,
One of our customers pointed out that the Proficio PCB Version 5.x can not be slid into the enclosure due to jumper JP2 being too close to the edge of PCB.  However the fix is easy.  Remove JP2 and install a short length of light gauge insulated hook up wire.   JP2 carries 13.8V and is intended to allow for the addition of an on/off switch (not yet available). 
The assembly manual has been updated with this information. 
Thank you for your support and business,
The Multus SDR,LLC Team,
Ron / W4MMP